The adjustment method of horizontal waste paper baler

1. The width of the belt and the adjustment of the joints when the width of the belt is not uniform or replace another width of the belt, you must adjust the left and right insertion slot is too narrow, inserting the belt is difficult; too wide, horizontal waste paper baler bundle after the belt joints will not lap. The general width of the insertion slot should be wider than the width of the tape by about 0.5-1 mm.
2, horizontal waste paper baler hot head temperature adjustment The temperature of the hot head has a great impact on the quality of the tape joint. In order to make the polypropylene strapping tape joints sticky, the knob is generally placed on the 3-5 gear position. Whether the temperature of the ironing head is suitable, you can check the bonding situation on the surface of the ironing head. If the surface of the ironing head has white traces, the temperature has been high; if the surface of the ironing head is moist, the temperature is not enough.
3 horizontal waste paper baler bundle bundle tightness adjustment Open the table panel, with the hands of the big mother A above the hexagonal set screws loose, clockwise direction for tight, and vice versa for loose. After the strapping force is moderate, tighten the hexagonal set screw.
The length of the feeding tape is decided by the tape length adjuster on the front panel. If the belt is too short, it is easy to tie the hand, then the horizontal waste paper baler can be used to grab the head of the belt along the feeding direction to pull the belt out. However, the belt feeding length needs to be readjusted again to ensure that the next bundling is carried out properly. Horizontal waste paper baler if the tape is too long, it is not easy to align the position, horizontal waste paper baler and loosening the tape is easy to wind up together causing the tape to inaccurate or broken.