Introduction of split type garbage compactor

Hydraulic system features in the split garbage compacting station

1、Vane pump, electromagnetic relief valve, electromagnetic reversing valve, speed control valve and other major components are imported components;

2、The hydraulic system is equipped with display devices for oil pressure, oil temperature, oil quantity and other parameters, and there are corresponding protection devices and alarm devices;

3、All seals of the hydraulic cylinder are imported parts to improve its long working life.

Product composition of split garbage compacting station

The composition of the garbage compressor in the split garbage compression and transfer equipment

1、Compression chamber: The bottom plate, side plate and top plate of the compression chamber are made of cold-rolled steel plate, with high structural strength and no deformation in extrusion, which improves the service life of the compression pushing head and the compression chamber.

2、Compression pushing mechanism: compression pushing mechanism is composed of compression pushing head and hydraulic cylinder, etc.;

Its main features are summarized as follows.

The compression push head is welded with steel plate, which improves its strength and increases the service life of the equipment;

The design of the compression push head takes into account the working cross-sectional area of the compression push head and the thrust of the extrusion cylinder, with a large compression force per unit area and good garbage compression effect.

3、Lifting door mechanism: lifting door mechanism consists of lifting hook, gantry, lifting door cylinder, etc. When the trash compactor is docked with the compressor, the lifting hook is lifted by the lifting door cylinder to lift the gate of the trash compactor, and the compression pushing mechanism pushes the trash into the trash compactor. When the garbage is full, the lifting mechanism will lower the door and close the garbage in the bin, and the garbage transfer truck will hook the bin away.

Workflow of garbage container of split type garbage compacting station

It consists of garbage container body, rollers, moving platform and moving track, etc. The unloaded split garbage container is sent to the transfer station with the garbage transfer truck and docked with the garbage compressor; the box body is pulled to the position of the garbage compressor by the push-pull box mechanism, the box holding device holds the box body tightly and the lifting gate mechanism lifts the gate, then the garbage compressing can be started; when a full box is compressed, the garbage compressor stops working and drops the When the full tank is pressed, the trash compressor will stop working, drop the gate, release the holding hook, and the push-pull box mechanism will push the tank away from the trash compressor.